La-crosse-technology WS-6020U-IT Uživatelský manuál

1 Battery cover Wall mount location Model WS-6020U-IT Solar Powered Wireless Temperature Station MANUAL/QUICK SETUP GUIDE

10 solar panel) or 2 x AA standard alkaline batteries (non-rechargeable; not included). The Temperature Station comes with special solar-rechargeabl

11 2. Slide the battery switch to the DOWN to select the alkaline battery. 3. Insert new, 2 x standard alkaline batteries into the compartment, obs

12 the batteries back into the Temperature station (slide the switch to the up if using the included solar-rechargeable batteries), press the RESET k

13 Ensure that the Temperature Station continuously receives the 915MHz signal from the Sensor before mounting it in the desired location. The Temper

14 light to recharge the internal power cell. It is best mounted on an East wall to receive cool morning sun to charge. Under an overhang will provid

15 SPECIFICATIONS: Indoor Temperature: Measuring range: 16°F to 140° ( “--.-“ or “--.0” is displayed when the indoor temperature is outside this ran

16 Warranty service can only be performed by a La Crosse Technology, Ltd authorized service center. The original dated bill of sale must be presente

17 accessory or decorative surface; (4) damage resulting from failure to follow instructions contained in your owner’s manual; (5) damage resulting f

18 La Crosse Technology, Ltd 2817 Losey Blvd. S. La Crosse, WI 54601 The complete instruction manual is available at: www.lacrossetec

19 FCC ID: OMO-M-10 (transmitter) FCC DISCLAIMER RF Exposure mobile: The internal / external antennas used for this mobile transmitter must provide

2 FEATURES  Receives wireless outdoor temperature Solar cell powers

20  Reorient or relocate the receiving antenna.  Increase the separation between the equipment and receiver.  Connect the equipment into an out

3 3. Next, slide the battery switch to the SOLAR (UP) position. WARNING Do NOT recharge the included solar-rechar

4 4. Continue to section labeled "ACTIVATE SOLAR-POWERED OUTDOOR TRANSMITTER" 5. If the solar panel is facing a permanent strong light

5 ACTIVATE SOLAR-POWERED OUTDOOR TRANSMITTER 1. Press the RESET key on the Sensor to activate the solar-powered transmitter and link it to the Tempe

6  It checks the brightness level of the surrounding environment every 5 seconds.  It measures / transmits every 16 seconds if it detects a dark

7 60W light bulb or similar condition) and press the RESET key to return to NORMAL MODE (battery voltage is higher than 2.5V). MIN/MAX: Press and re

8 LOW BATTERY INDICATOR: • RX Low battery indicator is displayed on the LCD when the receiver battery voltage is low. • TX Low battery indicator is d

9 Temperature Station, as the batteries may spring free from the contacts and force a false reset. Should this happen accidentally then reset all uni