La-crosse-technology WS-7034U Uživatelský manuál

WS-7034U Wireless 433 MHz Temperature Station Instruction Manual

10Adding Additional Remote Temperature Sensors (optional) The WS-7034U is able to receive signals from 3 different remote temperature sensors. Follo

11indoor temperature station and do not press any buttons for ten minutes. Transmission problems will arise if this is not done correctly. To view

12Remote Temperature Sensor 1. Remove the mounting bracket from the remote temperature sensor. 2. Mount the bracket in the desired location with

13temperature station over the screw and pull down to secure. TROUBLESHOOTING NOTE: For problems not solved, please contact La Crosse Technology v

14so the straight-line signal is not passing through more than two or three walls. Problem: Temperatures do not match if units are placed next to eac

15is difficult to compensate for the above factors and obtain an accurate comparison. MAINTENANCE AND CARE INSTRUCTIONS • Extreme temperatures, vib

16 SPECIFICATIONS Transmitting Frequency 433MHz Measuring Temperatures Indoor Temperature Station 32°F to 156.2°F with 0.2 °F resolution. (0°C to 6

17Sensor Indoor Temperature Station 2 x AAA, 1.5V Dimensions: (L x W x H) Indoor Temperature Station 2.36 x .88 x 5.90 in. (excluding table stand)

18 This warranty does not cover any defects resulting from improper use, unauthorized repairs, faulty batteries, or the indoor temperature stations i

19Phone: 608.782.1610 Fax: 608.796.1020 e-mail: [email protected] (warranty work) [email protected] (information on other p

2TABLE OF CONTENTS Topic Page Quick Setup 3-5 Inventory of Contents 6-7 Detailed Setup Guide Battery Installation 8 Setting the Time 9-10 Selec

20 FCC ID: OMO-01RX (Receiver), OMO-01TX (transmitter) THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO

3QUICK SETUP Hint: Use good quality Alkaline Batteries and avoid rechargeable batteries. 1. Have the indoor temperature station and remote temperat

4display will show both the indoor temperature and an outdoor temperature. If the indoor temperature station does not display both temperatures afte

5Figure 2 Figure 1 Holder NOTE: Fog and mist will not harm your remote temperature sensor but direct rain must be avoided. To complete the set up o

6Battery Cover ADDITIONAL EQUIPMENT (not included) 1. 1 Philips screwdriver. 2. 2 Fresh AAA Alkaline batteries. 3. 2 Fresh AA Alkaline batterie

7 Setting the Time 1. Press and hold the “SET” button for 5 second, “12h” will appear in the TIME LCD. 2. Press and release the “MIN/MAX” button to

8If there is no display here it is AM. Make sure you set the time accordingly. Selecting Units of Measurement 1. Press and hold the “SET” button f

92. The recorded minimum temperature is displayed. The time of the minimum outdoor temperature will also flash. 3. Press the “MIN/MAX” button, “MAX”